
Assembly of printed circuit boards and end products entirely in-house
In this way, Ampel-Tech can shorten the delivery time and reduce the costs for prototype and volume production.
Ampel-Technologies can take care of the assembly of printed circuit boards and end products entirely in-house.
With the operational experience we gain in this process, we can optimize our designs even further.
In addition, this way we can shorten the delivery time and reduce the costs for prototype and volume production.
For the purpose of this strategy, the production line has been optimized for lower volumes and a wide variety of products.
All products are designed and produced according to a very strict inline principle which significantly reduces the handling of the Print Circuit Board Assemblies.
This, in turn, ensures a higher quality of the final product.
The line itself consists of a Surface Mount Device (SMD) section and a Conventional Assembly Line (CAL).
The SMD part is fully automated and controlled with camera inspections. The SMD line has the ability to fit even the most advanced components such as BGAs, QFNs, QFPs, and 01005s. The CAL line consists of a Selective Wave machine that ensures the best quality on Through Hole (TH) components without damaging other components around it.

Ampel-Technologies supports plate sizes up to 450 mm x 400 mm and can take care of the assembly of the Print Circuit Board Assemblies in a finished product.
The provision of custom housings or cables is done in collaboration with our production partners.
This allows Ampel-Technologies to take full responsibility and provide the best service for products, from the design phase to the volume phase.
In order to minimize investment costs and maximize automation, Ampel Technologies is also able to produce at competitive prices.
If you are looking for a production partner who takes full responsibility and is flexible even with low volumes, we would like to get in touch with you!